BLE connection issue on iOS

This page explains how to validate that the Bluetooth layer of your Torpedo (C.A.B. M and Captor X) is properly working without using Torpedo Wireless Remote. To do so you have to install BLE Scanner 4.0 application.

 

In AppStore search "BLE scanner" and install BLE scanner 4.0

Ensure that Torpedo Wireless Remote is not running and launch BLE Scanner. All the reachable BLE devices should be listed. The devices do not have to be paired in order to be listed. Turn on your Torpedo, it then should appear in the list. Press "Connect" to initiate the pairing.

Enter the PIN code of your Torpedo:

  • Torpedo C.A.B. M: Go to the Global/BLE pin code screen (see section 4.3.6.6 of the user manual).
  • Torpedo Captor X: Enter 000 following by the 3 last digits of the serial number. If your serial number is 11950213 your pin code is 000213.

Once paired, BLE Scanner should be connected to your Torpedo. In order to validate that your Torpedo works properly, click on CUSTOM SERVICE:

Press "Updating" on the first listed service:

Press "Read value" several times. 0x000 value should be read every times:

If you managed to follow all these steps, your Torpedo works properly and you can retry to connect it using Torpedo Wireless Remote. Before launching Torpedo Wireless Remote ensure that BLE Scanner is disconnected from your Torpedo.